North Star 8000 IPG User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 11
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
10
TROUBLESHOOTING
Problem Possible Causes Possible Remedies
Engine will not start. a) Low oil level.
b) Fouled spark plug.
c) Out of fuel.
d) Stop switch in OFF position.
e) Battery has lost its charge.
a) Fill crankcase to proper oil level.
b) Clean or replace spark plug.
c) Fill fuel tank.
d) Place switch in ON position.
e) Battery has low electrolyte and/or
needs to be charged or replaced.
Voltage too low. a) Engine speed too slow.
b) Generator is overloaded.
c) Idle control is malfunctioning.
a) Bring generator to a qualified
technician for adjustment.
b) Reduce the load. (See Load
Application section of this manual.)
c) Bring generator to a qualified
technician for inspection.
Circuit breaker trips. a) Defective load connected to generator.
b) Defective receptacle.
c) Generator overloaded.
a) Disconnect load.
b) Replace receptacle.
c) Reduce the load. (See Load
Application section of this manual.)
Vol tage too high. a) Engine speed too high. a) Bring generator to a qualified
technician for adjustment.
Generator overheating. a) Generator is overloaded.
b) Insufficient ventilation.
a) Reduce the load. (See Load
Application section of this manual.)
b) Make sure there is at least 3 feet of
clearance on all sides of generator.
No output voltage. a) Defective load connected to generator.
b) Broken or loose wire.
c) Defective receptacle.
d) Defective stator.
e) Defective rotor.
f) Defective capacitor.
a) Disconnect load.
b) Bring generator to a qualified
technician for repair.
c) Replace receptacle.
d) Bring generator to a qualified
technician for repair.
e) Bring generator to a qualified
technician for repair.
f) Bring generator to a qualified
technician for repair.
Engine lacks power. a) Generator i s overloaded.
b) Dirty air filter.
a) Reduce the load. (See Load
Application section of this manual.)
b) Clean or replace air filter.
Idle control doesn’t
work.
a) Switch is in OFF position.
b) Solenoid failure.
c) Defective circuit board.
d) Defective capacitor.
e) Circuit breaker tripped
f) Engine idle speed to low-engine will not
jump back to normal operating speed
unless idle on/off switch is placed in off
position.
a) Place switch in ON position.
b) Check for 12 VDC at solenoid. Check
coil resistance, it should be 18.5Ω ±5%.
Check for sticking in mechanism and
solenoid. Replace idle assembly if
necessary.
c) Bring generator to a qualified
technician for repair.
d) Bring generator to a qualified
technician for repair.
e) Reset circuit breaker.
f) Raise engine idle speed by turning
engine throttle stop screw. See
carburetor adjustment section of the
Honda Owners Manual. Turn stop
screw ½ turn clockwise.
Engine shuts off during
operation.
a) Out of fuel.
b) Low oil level.
a) Fill fuel tank.
Fill crankcase to proper oil level.
Page view 10
1 2 ... 6 7 8 9 10 11

Comments to this Manuals

No comments