North Star M165923V.1 User Manual download pdf (Page 18)

Installation / Initial Set-Up

Grounding

Post

Copper

Pipe/Rod

10 Ga.

wire

5. Grounding the generator

Always ensure the generator is properly grounded to prevent electrical shock.

You must always ground the generator by the following method when using the generator as a

portable electrical source:

1) Drive a ¾” or 1” copper pipe or rod into the ground close to the generator. The pipe/rod

must

penetrate moist earth – the depth required will be dictated by local soil conditions.

Consult with an electrician.

2) Connect an approved ground clamp to the pipe.

3) Run a 10 gauge wire from the clamp to the generator grounding post located on the rear of

the generator head.

4) Do not connect the generator grounding post to a water pipe or a ground used by a radio

system.

If a licensed electrician installs the generator with a connection to your building’s electrical circuit

for use as a back-up power system, grounding may alternatively be completed through the

building’s grounding system. Ask your electrician. If the generator is not grounded through your

building’s electrical system, follow the procedure above.

WARNING:

Operating the generator when it is not properly grounded can result in electrical shock.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

No comments

North Star M165923V.1 User Manual Page 18